 |
 |
 |
 |
| Expanding Panel: 1. Pull legs out and locate snap buttons to lock into position. |
2. Black dot on leg lines up snap button | 3. Pull out on one side of panel body until snap buttons lock into position. | 4. Pull out on other side
of panel body until snap buttons lock into position. **Note panels have a high end side and a low end side for connecting panels, connect a high end side to a low end side. |
| To
Collapse Panel: Repeat steps in reverse order (4, 3, 2, 1) for easiest
handling. |
|||
 |
 |
 |
 |
| Connecting
Panels information Locate snap buttons on center twin tubes, depress buttons on twin tubes and push in on side of panel You will need to get the top slightly pushed in and then do lower snap button to collapse side of panel in completely |
Additional Connecting Panels information Black locking pins pin at 45, 90, 180 degress. Line up panels so that black locking pins drop thru both panels. |
Stake Kit Corral contains 5 bungee straps and 5 stakes. Corral can be staked by hooking bungee strap to lowest pin connection and other end to stake driven into ground. |
Trailer
Brackets Corral panels can be secured to trailer with 4 brackets included in standard corral unit. Lag bolts are not included to attach bracket to trailer wall as every trailer is different. Panel will secure to bracket with black locking pins. Black locking pins can be replaced with 1/2" bolts if desired. Setup corral next to desired location on trailer to determine trailer bracket position. Use two brackets per attachment end. |
